- White or ecru clay polymer clay (I prefer white) clay any brand except sculpeyIII
- 2 alcohol inks for highlight, I use Ranger inks
- alcohol ink for deep accent color
- alcohol blending solution in spritzer bottle
- alcohol applicator and pads
- Clean paint brush smallest you have
- Texture stamp in the above example I used the leaves stamp
- I like a small design for full impact
- Teardrop cutter I use Premos teardrop mini cutter set
- Round Cutter to fit I use Premos Round mini cutter set
- Roller acrylic
- Pastel chalks
- acrylic paint
- Kato poly paste if needed
1. start by conditioning your clay about 1/4 to 1/2 block is plenty. Then roll out to the thickness you desire for this project mine is about 1/4″
2. Using the your pastels in this case I used stick pastels that I had to scrape to get my pastel powder. BE SURE TO USE A HIGH QUALITY pastel that insures intense colors.
3. Using the powders you created rub the colors into the clay. I like to keep the colors separate these will be the colors that peek through.
4. press your stamp into the clay being sure you have good depth of the design.
5. Squirt lightly with blending solution, also apply blending solution to your applicator pad. Next add a couple of drops of the ink colors you choose to the applicator pad. keep them separate and use sparingly.
6. Lightly apply on top of the chalk in a few places.
7. Now using a clean applicator pad, add a small about of blending solution if necessary. Gently wipe some of the top ridges of the design clean (ish) of the pastels.
8. Now drop a couple of drops of you alcohol ink onto container or plate. *see below for hint. Spritz your clay piece again with the blending solution this will allow the ink to move. Don’t over saturate the clay. Using your fine tip paint brush lightly touch a small tip of alcohol ink into the recesses of the design to accent. Don’t over do just a bit here and there. notice in this piece that I have used cranberry and blue sparingly in a few places.
9. Let it dry to the touch then cut your shapes I used the smallest teardrop from the premo set. Arrange the design into a flower. I used the inside of my hollow bead maker to hold the cupped shape I wanted and pinched and curved the petals to my liking. Press together add the center, gently press to be sure all areas are touching well, and cure according to manufacture directions.
10. Now notice on my finished piece the light green highlights that was achieved after the piece was cured and I very lightly dry brushed some green acrylic paint in just a few places adding yet another dimension.
11. On occasion the bond will not hold after it is cured because of the layer of chalks and inks. DO NOT PANIC all is not lost. I almost prefer it to show any weakness. After it is cured I just give my best kept secret Kato Poly Paste a bit of a stir to be sure its nice and sticky and using my finger rub a bit onto the piece to be secured like glue and then cure again. Don’t forget to tent your piece to keep it from scorching. This is also what I use to attach my clay bails.
Enjoy and have fun Remember some times you just have to make a mess to find the beauty within!
*HINT for alcohol inks